Table of Contents
Advertisement
Using the Remote Control
UsingAutomatic CodeSearch
The following instructions can be usedto program the remote to operate your
components. If you want to stop the automatic code search without programming
any of your components, pressCLEAR until the indicator on the remote turns off.
1. Turn on the component you want to operate (VCRor DVDplayer)
2. Pressand hold the component button you want to program (VCR,DVD,or
VPORT). W hile holding the component button, pressand hold ONoOFEuntil the
indicator on the remote turns on, then releaseboth buttons.
3.
Point the remote at the component.
Press and release PLAY, then wait 5
seconds or until the indicator
on the remote stops flashing.
At this point the remote is searching for the correct code to program. If, after 5
seconds, the component
you want to operate does not turn off, press PlAY
again to tell the remote to search the next set of codes.
Continue
pressing PLAY until the component
turns off or you have searched
through
all of the codes. There are 20 total sets of codes. If the component
does not turn off after pressing PlAY 20 times, then the remote can't be
programmed to operate that component.
If the component
you want to control
does turn off:
1. Press and release REVERSE,then wait 2 seconds. Repeat this step until the
component
turns back ON.
2. To finish, press and hold STOP until the indicator
on the remote turns off.
Using Direct Entry
1. Turn on the component
to be programmed.
2.
Look up the brand and code number(s) for the component
on the code list in
this section.
3.
Press and hold the component
button you want to program on the remote.
4.
Enter the code from the remote control code list on the following
pages. If the
indicator
flashes, you have either entered an invalid code or the button
isn't
programmable.
5.
Release the component
button.
6.
Point the remote at the component.
Press ONeOFF to see if the component
responds to the command. If it doesn't, try pressing the component
button
and
then ONeOFF again.
•
If you get no response, repeat these steps using the next code listed for your
brand, until the component
responds to the remote commands.
•
If you try all the codes for your component
brand and none work, try the
automatic
code search method. If automatic
code search doesn't find the code,
the remote is not compatible
with your component.
Chapter 2
Graphics contained
within this publication
are for representation
only.
1 1
Advertisement
Table of Contents
Need help?
Do you have a question about the 27V550 and is the answer not in the manual?